After a leak, the surfaces dry fast while the structure stays wet. Framing, subfloors, and wall cavities hold moisture you cannot see. Structural drying uses measured airflow and dehumidification to bring those materials back to normal moisture levels.
Free referral to independent, licensed and insured local pros. Zip codes served include 54952 54956.

We are a referral line, not a contractor. Calls are routed to independent local pros around Fox Crossing who treat drying as a measured process with daily readings and written logs.
Low-grain refrigerant dehumidifiers pull moisture to levels standard units cannot reach. Desiccant units handle cold spaces and dense materials. Air movers are placed at specific angles to sweep moisture off wet surfaces.
Daily logs track humidity and material readings so drying decisions are based on data.
Each contractor runs an independent, licensed and insured business. Confirm both with the pro before equipment is set.
You will see equipment day rates and an estimated drying timeline before setup.

The goal is simple: get every wet material back to the moisture level of similar dry materials in the house, and prove it with readings.

Meters and thermal imaging trace water into hidden spots before drying begins.
Sealing off the wet area with plastic focuses the equipment and shortens drying time.
Injecting dry air through small holes can dry wall cavities without full flood cuts.
Floor mat systems and targeted airflow dry hardwood and plywood subfloors slowly enough to limit cupping and cracking.
Drying ends only when readings confirm the structure is dry, and you get the log for your records.
Tell the dispatcher when the leak happened and what has been done so far.
A local contractor calls back with an arrival time and brings meters, a thermal camera, and an initial set of drying equipment.
The pro maps moisture, records dry standard from unaffected areas, calculates equipment needs, and gives you a written estimate.
Drying continues with daily monitoring until readings confirm the job is done.
Closing up wet framing is how mold starts.
A week of box fans did nothing. The pro found wet framing with infrared and dried it properly in four days.
Laura F.Hidden wet framing after leakWall injection drying saved our drywall. Just a few small holes behind the baseboards.
Kevin Y.Wall cavity dryingI liked seeing the daily log. Humidity numbers, wood readings, all of it. The adjuster liked it too.
Mariah S.Insurance drying documentationOur oak floor was cupping. They used floor mats and kept the drying slow and steady. The boards flattened back out.
Henry L.Hardwood floor drying

Typically three to five days, longer for hardwood, plaster, or concrete.
Consumer equipment is too weak to dry framing quickly enough to prevent mold.
Dry standard is the normal moisture reading of the same type of material in an unaffected part of the home. Drying is complete when wet materials match it.
Grains per pound, or GPP, measures how much water vapor is in the air. Lowering GPP in the drying area speeds evaporation from wet materials.
Yes. Air movers and dehumidifiers are noisy and add heat. Most people can stay home, but you may want to close doors to the drying area at night.
No. We connect you with independent local pros. Confirm their license and insurance before work starts.

Independent drying specialists in the network serve Fox Crossing, WI and nearby zip codes like 54952 54956.
Nearby cities are listed below.
